Gree GWH07NA-K3NNE4E - 6.1 Remote Controller Introduction of YX1 F

14
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction of YX1F
AUTO
COOL
DRY
FAN
HEAT
T-ON T-OFF
SWING
SLEEP
LOCK
SPEED
+
_
ON/OFF
FAN SWING
SLEEP
TIMER
MODE
ON/OFF button
MODE button
+/- botton
FAN button
SWING button
SLEEP button
TIMER button
Icon Display on Remote Cont
roller
Operation introduction of remote controll
er
For auto operation
Timer on Timer off
Sending signal
For air swing
For sleeping
For locking
For setting fan speed
Set temperature
Set time
For cooling
For drying
For fan only
For heating
AUTO
COOL
DRY
FAN
HEAT
T-ON T-OFF
SWING
SLEEP
LOCK
SPEED
Buttons on Remote Controller
1. ON/OFF Butto
n
Press this button to turn unit on/o
ff.
2. MODE Butto
n
Pressing this button once can select your required mode circularly as below(the corresponding icon
will be lit up after the mode is
selected)
:
AUTO COOL DRYFAN HEAT
Note:
● This is a general use remote controller, it could be used for the air conditionerswith multifunction; For some function, which the
model doesn't have, if pressthe corresponding button on the remote controller that the unit will keep theoriginal running status.
● When power is connected(stand by condition), you can operate the air conditioner through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending signal icon " " on the display of remote
controller will blink once. If the air conditioner gives out a beep sound, it means the signal has been sent.
● When unit is off, set temperature will be displayed on the remote controller (If the light of indoor unit display is turned on, the
corresponding icon will be displayed);When unit is on, it will display the icon of the on-going function.