Gree GWH09AB-D3DNA1D/I - Digital Display; Remote Controller Description


(WPEVKQPCPF%QPVTQN
19
SLEEP icon :
is displayed by pressing the SLEEP button. Press this button again to clear the display.
TEMP icon:
Pressing TEMP button, (set temperature), (ambient temperature), (outdoor ambient temperature) and blank is displayed circularly.
Up & down swing icon:
is displayed when pressing the up & down swing button. Press this button again to clear the display.
LIGHT icon:
is displayed by pressing the LIGHT button. Press LIGHT button again to clear the display.
LOCK icon:
is displayed by pressing "+" and “-” buttons simultaneously. Press them again to clear the display.
SET TIME display:
After pressing TIMER button, ON or OFF will blink.This area will show the set time.
TURBO icon:
is displayed when pressing the TURBO button.Press this button again to clear the display.
DIGITAL display:
This area will show the set temperature. In SAVE mode,"SE" will be displayed. During defrosting operation, “H1” will be displayed.
AIR icon:
is displayed when pressing the AIR button.Press this button again to clear the display.
I FEEL icon:
is displayed when pressing the I FEEL button. Press this button again to clear the display.
FAN SPEED display:
Press FAN button to select the desired fan speed setting (AUTO Low-Med-High).Your selection will be displayed in the LCD windows,
except the AUTO fan speed.
HEALTH icon:
is displayed when pressing the HEALTH button. Press this button again to clear the display.
X-FAN icon:
is displayed when pressing the X-FAN button. Press this button again to clear the display.
21
20
22
23
24
25
26
27
28
29
30
31
1
2
3
4
ON/OFF:
Press this button to turn on the unit .Press this button again to turn off the unit.
-:
Press this button to decrease set temperature. Hold it down for above 2 seconds to rapidly decrease set temperature. In AUTO mode,
set temperature is not adjustable.
+:
Press this button to increase set temperature. Hold it down for above 2 seconds to rapidly increase set temperature. In AUTO mode,
set temperature is not adjustable.
FAN :
This button is used for setting Fan Speed in the sequence that goes from AUTO, , to then back to Auto.
Low speed Medium speed High speed
,
AUTO
Remote Controller Description
MODE icon:
18
If MODE button is pressed, current operation mode icon (AUTO), ( COOL), (DRY), (FAN) or (HEAT only for
heat pump models) will show.