Gree GWH09ACC-K6DNA1A/I - Attachment Details; Connection Pipe Configuration

15
Function introduction for combination buttons
Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to
start up or turn off energy-saving function. When energy-saving function is started
up, "SE" will be shown on remote controller, and air conditioner will adjust the set
temperature automatically according to ex-factory setting to reach to the best
energy-saving effect. Press "TEMP" and "CLOCK" buttons simultaneously again to
exit energy-saving function.
Note:
Under energy-saving function, fan speed is defaulted at auto speed and it can’tƔ
be adjusted.
16
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit’s display. The setting on
remote controlleris selected circularly as below:
no display
Ɣ When selecting " " or no display with remote controller, temperature indicator
on indoor unit displays set temperature.
Ɣ When selecting " " with remote controller, temperature indicator on indoor unit
displays indoor ambient temperature.
Ɣ When selecting " " with remote controller, temperature indicator on indoor unit
displays outdoor ambient temperature.
Note:
Ɣ Outdoor temperature display is not available for some models. At that time, indoor
unit receives " " signal, while it displays indoor set temperature.
Ɣ It s defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
Ɣ Only for the models whose indoor unit has dual-8 display.
Ɣ When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
WRGLVSOD\VHWWHPSHUDWXUHDIWHUWKUHHRU¿YHVHFRQGV
LCD displays " ". Press the button for the second time to start healthy and
scavenging functions simultaneously; LCD displays " " and " " . Press this
button for the third time to quit healthy and scavenging functions simultaneously.
Press the button for the fourth time to start healthy function; LCD display " " .
Press this button again to repeat the operation above.
Ɣ This function is applicable to partial of models.
Introduction for buttons on remote controller