Medium fanLow fan High fanMedium-low fan Medium-high fan
ATUO
AUTO COOL DRY FAN HEAT
OFF
Note:
● It’s Low fan speed under Dry mode.
● X-FAN function：Hold fan speed button for 2s in COOL or DRY mode, the icon “ ” is displayed and the indoor fan will continue
operation for a few minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN OFF is
defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed after the unit is stopped to avoid mould.
● Having set X-FAN function on: After turning off the unit by pressing ON/OFF button indoor fan will continue running for a few minutes. at
low speed. In this period, Hold fan speed button for 2s to stop indoor fan directly.
● Having set X-FAN function off: After turning off the unit by pressing ON/OFF button, the complete unit will be off directly.
Press " + " or " - " button once increase or decrease set temperature 1°C(°F). Holding " + " or " - " button, set temperature on remote
controller will change quickly. On releasing button after setting is finished, temperature indicator on indoor unit will change accordingly.
When setting TIMER ON, TIMER OFF or CLOCK, press " + " or " - " button to adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF
buttons)
OFF
Heat mode, the initial
value is 20°C(68 °F ).Under other modes, the initial value is 25°C(77°F).
Press this button can select up & down swing angle. Fan blow angle can be selected circularly as below:
When selecting " ", air conditioner is blowing fan automatically. Horizontal louver will automatically swing up & down at maximum angle.
When selecting " 、 、 、 、 ", air conditioner is blowing fan at fixed position.
Horizontal louver will stop at the fixed position.
● When selecting " 、 、 ", air conditioner is blowing fan at fixed angle. Horizontal louver will send air at the fixed angle.
●Hold " " button above 2s to set your required swing angle. When reaching your required angle, release the button.
Notice :
" 、 、 " may not be available. When air conditioner receives this signal, the air conditioner will blow fan automatically.
To Next Page
Loading...
