71
Installation and Maintenance
Service Manual
Step Procedure
10. Remove Motor
Remove 3 screws used for fixing the motor
mounting plate and then remove the motor
mounting plate.
Pull it to the right side forcibly and then the motor
can be remove from the installation hole of motor
support.
11.Remove Driving Box Sub-assy
Pull the claps of driving box fixed at the base,
rotate it upwards and then the driving box sub-assy
can be removed. (the disassembly method for the
left&right driving box is the same)
Cold plasma
Screw of
grounding wire
Tube temperature
sensor
Screws
Motor
Left Driving Box
Sub-assy
Right Driving Box
Sub-assy
Clasp
To Next Page
Loading...
