Gree GWH09RB-K3DBA3E - Page 71


,QVWDOODWLRQDQG0DLQWHQDQFH
6HUYLFH0DQXDO
4
cross flow blade
fan mtor
O-Gasket sub-assy of Bearing
stepping motor
motor press plate
2
ring of bearing
1
3
5
9. Remove cross flow blade and motor
Remove screws on stepping motor, and then remove
the stepping motor.
Remove 4 screws connecting motor press plate and
bottom case, and then remove motor press plate.
Remove cross flow blade and motor.
Remove shaft rubber cushion block.
Remove screws connecting cross flow blade and motor
shaft, and then remove motor.