73
Technical Information
Service Manual
Note:
Note:
Note:
● Press this button continuously more than 2s, the main unit will swing back and forth from left to right, and then loosen the
button, the unit will stop swinging and present position of guide louver will be kept immediately.
● Under swing left and right mode, when the status is switched from off to , if
press this button again 2s later
, status will
switch to off status directly; if press this button again within 2s, the change of swing status will also depend on the circulation
sequence stated above.
Press this button can select left & right swing angle. Fan blow angle can be selected
circularly as below:
no display
(stops at current position)
Press this button can select up & down swing angle. Fan blow angle can be selected
circularly as below:
● When selecting " ", air conditioner is blowing fan automatically
● T-ON button
"T-ON" button can set the time for timer on. After pressing this button, " " icon disappears and the word "ON" on remote
controller blinks. Press "▲" or " " button to adjust T-ON setting. After each pressing "▲" or " " button, T-ON setting will
increase or decrease 1min. Hold "▲" or " " button, 2s later, the time will change quickly until reaching your required time.
Press "T-ON" to confirm it. The word "ON" will stop blinking. " " icon resumes displaying. Cancel T-ON: Under the condition
that T-ON is started up,press "T-ON" button to cancel it.
. Horizontal louver will automatically swing up & down
at maximum angle.
● When selecting "
ǃǃǃǃ
", air conditioner is blowing fan at fixed
position. Horizontal louver will stop at the
fixed position.
● When selecting "
ǃǃ
", air conditioner is blowing fan at fixed angle.
Horizontal louver will send air at the fixed
angle.
● Hold " " button above 2s to set your required swing angle. When reaching your
required angle, release the button.
● "
ǃǃ
" may not be available. When air conditioner receives this signal, the air conditioner will blow fan automatically.
● Press this button continuously more than 2s, the main unit will swing back and forth from up to down, and then loosen the
button, the unit will stop swinging and present position of guide louver will be kept immediately.
● Under on and off status, you can set T-OFF or T-ON simultaneously.
● Before setting T-ON or T-OFF, please adjust the clock time.
● After starting up T-ON or T-OFF, set the constant circulating valid.After that, air conditioner will be turned on or turned off
according to setting time. ON/OFF button has no effect on setting. If you don’t need this function, please use remote controller
to cancel it.
● Under swing up and down mode, when the status is switched from off to , if press this button again 2s later,
status will switch to off status directly; if press this button again within 2s, the change of swing status will also depend on the
circulation sequence stated above.
no display
(horizontal louvers stops
at current position)
button
T-ON / T-OFF button
▲
▲
▲
When I FEEL function is turned on, the remote controller should be put within the area where indoor unit can receive the signal sent by the
remote controller.
To Next Page
Loading...
