65
Electrical Component Reference
Base Pan Heater Check
Base Pan Heater Resistance Check:
Unplug the wire connector from the circuit board. e resistance should read approximately 740 ohms. ere
should be no reading from either wire to ground. If readings vary from these measurements, replace the heater.
Compressor Crankcase Heater Resistance Check:
Unplug the wire connector from the circuit board. e resistance should read approximately 2.15K ohms. ere
should be no reading from either wire to ground. If readings vary from these measurements, replace the heater.
Compressor Crankcase Heater Check
To Next Page
Loading...