88
Installation and Maintenance
Service Manual
7. Remove axial flow blade
Remove the nut on the blade and then remove the
axial flow blade.
8. Remove motor and motor support
Remove the 4 tapping screws fixing the motor and
disconnect the leading wire insert of the motor.
Then remove the motor.
Remove the 2 tapping screws fixing the motor
support and lift the motor support to remove it.
9. Remove electric box
Remove screws fixing the electric box subassembly;
loosen the wire bundle and unplug the wiring
terminals. Then lift the electric box to remove it.
motor
motor support
electric box
axial flow blade
Steps
To Next Page
Loading...
