42
Technical Information
Service Manual
6. Function and Control
6.1 Remote Controller Introduction
Introduction for icons on display screen
TURBO
FAN
MODE
ON/OFF
I FEEL
T-ON T-OFF
TEMP
CLOCK
LIGHT
WiFi
SLEEP
Set temperature
WiFi function
Sleep mode
8
heating function
Health mode
Scavenging function
Quiet
X-FAN function
Set temp.
temp.
Outdoor ambient
temp.
Indoor ambient
Clock
Operation mode
Set time
Turbo mode
Send signal
Auto mode
Cool mode
TIMER ON / TIMER OFF
Left & right swing
Up & down swing
Child lock
Dry mode
Fan mode
Heat mode
Temp.
I feel
Set fan speed
display type
●
Notice
:
doesn't have, if press the corresponding button on the remote controller
, the unit will keep the original running status.
This is a general use remote controller. It could be used for the air conditioner with multifunction. For the functions which the model
the air conditioner by using remote controlle
r.
After putting through the power, the air conditioner will give out a sound. Operation indicator "" is ON. After that, you can operate
and the air conditioner will give out a "di" sound, which means the signal has been sent to the air conditioner
.
Under on status, pressing the button on the remote controller, the signal icon " " on the display of remote controller will blink once
MODE
Press this button to select your required operation mode.
ON/OFF
MODE
Press this button to turn on the unit. Press this button
to turn off the unit.
When selecting auto mode, air conditioner will operate●
AUTO COOL RY FAN HEATD
●After selecting cool mode, air conditioner will operate under
automatically according to ex-factory setting. Press "FAN
button can adjust fan speed. Press "" / " " button ca
adjust fan blowing angle.
● When selecting dry mode, the air conditioner operates
cool mode. Cool indicator " " on indoor unit is ON. (This
indicator is not available for some models.) Press "▲" or
" ▼ "button to adjust set temperature. Press "FAN" button
to adjust fan speed. Press " " / " " button to adjust
blowing angle.
●When selecting fan mode, the air conditioner will only blow
at low speed under dry mode. Dry indicator " " on indoor
unit is ON. (This indicator is not available for some models.)
Under dry mode, fan speed can’t be adjusted. Press " " /
" "button to adjust fan blowing angle.
When selecting heating mode, the air conditioner operates●
fan, no cooling and no heating. All indicators are OFF.
"FAN" button to adjust fan speed. Press " " / " " button to
adjust fan blowing angle.
●For preventing cold air, after starting up heat mode, indoor
unit will delay 1~5 minutes to blow air (actual delay time
depends on indoor ambient temperature).
under heat mode. Heat indicator " " on indoor unit is
(This indicator is not available for some models.) Press
or " ▼ " button to adjust set temperature. Press "FAN"
to adjust fan speed. Press " " / " " button to adjust
blowing angle. (Cooling only unit won’t receive heating
signal. If setting heat mode with remote controller, press ON/
OFF button can’t start up the unit).
Notice:
To Next Page
Loading...