Gree GWH24YE-S6DBA2A/O - Page 25

22
Installation and Maintenance
Service Manual
Operation Guide
Replacement of Batteries in Remote Controlle
r
1. General operatio
n
(1)After powered on, press ON/OFF button, the unit will start to run. (Note: When it is powered on, the
guide louver of main unit will close automaticall
y.)
(2)Press MODE button, select desired running mode.
(3)Pressing + or - button, to set the desired temperature (It is unnecessary to set the temp. at
AUTO
mode.)
(4)Pressing
FAN button, set fan speed, can select AUTO FAN,LOW, MEDIUM-LOW, MEDIUM, MEDIUM-
HIGH and HIGH
.
2. Optional operation
(1)Press SLEE
P button, to set sleep.
(2)Press
TIMER ON and TIMER OFF button, can set the scheduled timer on or timer off.
(3)Press LIGH
T button, to control the on and off of the displaying part of the unit (This function may be not
available for some units).
(4)Press
TURBO button, can realize the ON and OFF of TURBO function.
cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar are
correct.
3. Reinstall the cover of battery box.
Note:
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there
should be no obstacles between them.
remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there’s no display, please replace batteries.
5
1
2
3
4
(5)
Pressing and button, to select the swing.
batter
y
Cover of battery box
remove
reinstall
1
2
3
4