Gree LSQWRF35VM/NaA-M - Page 45

40
Fig 4-16 Parameter Page 4
No Name No Name
1
Entering water-T
10
Suction temperature 1
2
Leaving water-T
11
Suction temperature 2
3
Defrosting temperature 1
12 Shell-and-tube inlet-T 1
4
Defrosting temperature 2
13 Shell-and-tube inlet-T 2
5
Discharge temperature 1
14 Shell-and-tube outlet-T 1
6
Discharge temperature 2
15 Shell-and-tube outlet-T 2
7
Anti-freezing-T
16
Water-T for energy saving
8
Anti-over-heating-T
17
High pressure sensor 1
9
Ambient temperature
18
High pressure sensor 2
[Note]
1)“N/A” will be displayed when the temperature value for the corresponinidng mode or unit
doesn not exist or is invliad.
2)For item 7 and 8 in the table above, when “Mode” is set to “Cool”, only “Anti-freezing-T”
will be displayed; when “Mode” is set to others, only “Anti-over-heating-T” will be displayed.
(3)Error
Operation Instruction
By touching“Error”, the control will access to the error check page. When there is no any
error, the control panel will show as below.
A Series Modular-type Air-cooled (Heat Pump) Chiller