DC Inverter U-Match Series Cassette Type Unit
33
Notice
(1) Improper screw looseness will lead to the following problem.
Gas leakage of
ceiling
Condensate Water drops
Gas leakage
(2) After the screws are tightened, if there is still a gap between the ceiling
and the decorative front panel, adjust the height of the unit again (as
shown below).
No seam
If the lifting level of indoor unit and the drain pipeline
won't be affected, it's fine to adjust the height of
indoor unit through the holes on the corners of the
front panel.
(3) After installing the front panel, make sure there’s no gap between the unit
and the front panel.
(4) Circuit of the decorative front panel.
Connect the front panel to the main body through the corresponding slots.
Match the slots according to their different size.
To Next Page
Loading...
