Gree U-Match GUD160W/A-X - Page 58

DC Inverter U-Match Series Cassette Type Unit
54
How to clean the air filter
(4) Fix the 3 cleaners on the filter and then
re-install the filter by fitting it into the protruding
parts on top of the air intake grill. Pull the
handle at the back of the air intake grill to
secure the filter.
-
(5) Close the air intake grill.
Push the clasps outward and then match the
air intake grill with the main body. Loose the clasps
and then close it.
-
5.3.2 Clean Air Intake Grill
How to clean the air intake grill
(1) Open the air intake grill.
Same with step 1 in “Clean Air Filter”.
(2) Take out the air filter.
Same with step 2 in “Clean Air Filter”.
(3) Take out the air intake grill.
(Open the air intake grill at an angle
of 45 degrees, and then lift it up.)
(4) Cleaning.
Use soft brush, water, neutral
detergent to clean. After cleaning, shake
off the water or let it dry.
Notice: do not
use hot water (above 45°C) to clean,
otherwise the filter may be discolored or
out of shape.
(5) Install the air intake grill.
Refer to step 3.
(6) Install the air filter.
Same with step 4 in “Clean Air Filter”.
(7) Close the air intake grill.
Refer to step 1.
5.3.3 Drainage Pipe
Periodically check if the drainage pipe is blocked to smooth the condensate
water.
5.3.4 Notices at the Beginning of the Using Season
(1) Check if there is blockage at the inlet or outlet vent of air conditioner.
(2) Check if the earth wire has been attached reliably by the skilled
serviceman.