Green Machines 400 Series User Manual (English)

Other manuals for Green Machines 400 Series

Questions and Answers:

rkaneAug 17, 2025

Why is my Green Machines 400 not picking up debris?

N
nrodriguezAug 17, 2025
If your Green Machines Blower shows poor sweeping performance, such as not picking up debris or leaving a trail, there are several potential causes. The engine speed might be too low, so try increasing it. You might be operating the machine too fast, so try slowing down. The inner plastic sack could be full, requiring you to empty or replace it. The filter bag may be clogged; shake it to remove dust, and rinse or wash it if necessary. A wet filter bag can also cause issues; open the side zipper to vent it and the sludge door to drain water, and pierce small holes in the inner plastic bag for drainage. Check for blockages in the vacuum hose, and ensure the front flap is closed. Adjust the vacuum nozzle to a lower height and clear any blockages from the back duct or filter screen.

Johnathan CummingsAug 20, 2025

What to do if my Green Machines 400 engine is overheating?

E
erin19Aug 20, 2025
If your Green Machines Blower is overheating, several factors could be responsible. The radiator or coolant system might be blocked, so clear any blockages. Low engine coolant level can cause overheating, so add coolant to the reservoir. Using the wrong coolant or coolant mixture can also lead to this issue, so drain and replace it with the correct one. Debris in the impeller can cause overheating, so remove any obstructions. Finally, bad or contaminated diesel fuel can be a culprit; drain the bad fuel and refill with fuel from a different source.

Brand

Model

400 Series