Need help?Do you have a question about the Greenbroz 215 and is the answer not in the manual?
Shuts down the motor when the lid is opened.
Stationary lower and rotating upper blades for trimming.
Remove machine from container, save packing materials for storage.
Remove the top blade carefully, avoiding the cutting edge.
Clean blades and chamber with alcohol using a microfiber cloth.
Gently slide blade into chamber, aligning notch with drive shaft.
Test stems for snapping and leaves for brittleness.
Add material to chamber below brush, avoiding overfilling.
Plug in, turn ON, set direction to FORWARD, start timer.
Monitor progress, check trim bin, adjust brush height as needed.
Place container at exit, open door to collect trimmed material.
Ensure the machine is unplugged before starting any cleaning procedures.
Clean underside, brush arm, hub, and top blade with tools.
Covers defects in material/workmanship for 12 months from purchase.
To Next Page
General