greenhouse sensation click&drip P00GS48A User Manual

1
Battery compartment &
2
Battery compartment cover
Slide out the battery compartment
1
, and insert
2x (LR03/AAA) 1.5V alkaline batteries.
WARNING
A. Use only fresh alkaline batteries at the beginning
of the season. DO NOT use rechargeable batteries.
B. Test the unit by turning the Run Time knob to ON
position. You should hear the sound of the motor
within 10 seconds. If you do not hear the sound,
check if the batteries are installed correctly.
C. Turn Run Time to OFF position before connecting
to tap.
3
3/4" Tap adaptor and
4
Collar ring.
Turn the collar ring loose
4
until the tap adaptor
3
is
unlocked, screw the tap adaptor
3
on to the tap tight
and then lock them tight with the collar ring
4
.
WARNING
DO NOT use spanners or pliers to avoid damage
to the timer.
Water Timer
Instructions
Model Number: P00GS48A
Timer Features
⑦
⑤
③
⑩
④
⑨
⑧
②
①
⑥
5
Frequency knob
Determine how often you will water, from 1 hour to 1 week.
6
Run Time knob
Choose how long to water, from 1 minute to 120 minutes.
7
Male snap-on connector
Connect hose attachment to the male snap-on connector
7
at the bottom of the timer.
8
Delay button
To delay the start watering time press Delay button for
more than 3 seconds until led is constantly ON, then
each press of delay button means 1 hour delay of the
next start watering time (EXAMPLE 3).
9
Led indicator
Led indicator ashes once every 4 seconds.
WARNING
Replace with new batteries if led indicator ashes quickly
or continually on.
10
Filter
Filter traps dirt particles and prolong life of timer.
WARNING
Clean lter regularly and replace if worn.
PROGRAM TIMER
1. Set Frequency (determine how often you will water,
from 1 hour to 1 week.)
2. Set Run Time (determine how long to water,
from 1 minute to 120 minutes.)
NOTE: The rst watering will start X hours later, X is the
set frequency hours.
WARNING
Frequency should always be longer than Run Time.
(Example: Frequency=1H, Run Time=90 minutes,
is NOT a valid setting.)

greenhouse sensation click&drip P00GS48A Specifications

General

Suitable for	Greenhouses
Usage	Watering
Water Source Compatibility	Standard Garden Hose
Material	Plastic
Type	Drip irrigation system
Installation	DIY, Tool-Free

Summary

Timer Features and Components

Frequency and Run Time Knobs

Controls watering frequency (1hr-1wk) and duration (1min-120min).

Delay Button and LED Indicator

Manages delayed watering start and provides visual status feedback.

Battery Compartment and Installation

Instructions for inserting and testing alkaline batteries with warnings.

Tap Connection and Adapter

How to attach the timer to a water tap using the adaptor and collar ring.

Timer Programming and Setup

Setting Watering Frequency

Determine how often you will water, from 1 hour to 1 week.

Setting Watering Duration

Choose how long to water, from 1 minute to 120 minutes.

Programming Rule: Frequency vs. Run Time

Frequency must be longer than Run Time for valid settings.

Timer Operation and Usage

Setting Initial Watering Schedule Examples

Examples for setting frequency and run time for daily watering.

Adjusting Settings After Initial Setup

Notes on minimum wait times and how changes affect the next watering start.

Manual Watering Mode

How to manually start and stop watering using the Run Time knob.

Timer Protection and Maintenance

Usage Limitations and Environment

Designed for outdoor use, specifies pressure, water type, and temperature limits.

Winter and Freezing Conditions

Instructions for protecting the timer during winter or freezing weather.

General Care and Warnings

Advice on water resistance, vertical installation, avoiding submersion, and proper hose attachment.