Hydraulic Punch Driver
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
5
Setup and Operation Instructions
1. Remove the dust caps from the couplers; attach the
hose to the ram and to the pump. Thread the dust
caps together.
Note: Hand-tighten the couplers completely until all
threads are engaged. Do not use tools.
2. Select the punch, die, and draw stud that will make
the appropriate size hole.
3. Determine and mark the exact location for the hole.
Using a drill bit that is slightly larger than the draw
stud, drill a hole. This is the pilot hole.
4. Thread the 3/4" piston shaft (B) completely into the
ram (A). Refer to the illustration.
Note: For a punch and die with a 3/8" center hole,
thread the 3/8" adapter draw stud (F) into the end of
the piston shaft. For a punch and die with a 1-1/8"
center hole, thread the screw sleeve (E) onto the
piston shaft.
5. Install spacers as necessary. Refer to the illustra-
tions on this page.
6. Slide the die over the draw stud with the open end
of the die facing away from the ram.
7. Insert the draw stud through the pilot hole.
8. Thread the punch onto the draw stud with the
cutting surfaces of the punch facing the material.
Tighten the punch by hand until the spacers, die,
material, and punch are snug.
Note: All of the punch threads must be engaged by
the draw stud threads. If any of the punch threads
are not engaged, dis-assemble the setup, remove
one of the spacers, and reassemble the setup.
Do not operate the pump after ram motion stops.
Continuing to operate the pump lever after the ram
stops will damage the ram.
Note: If the ram stops before the hole is complete,
stop pumping. Check that the setup is correct
and that you have not exceeded the tool’s capac-
ity. Refer to the setup instructions. If necessary,
disassemble the setup and add a spacer.
9. Activate the pump. For specic instructions, refer to
the operating manual supplied with the pump.
Note: Support the weight of the ram when operat-
ing the pump. This will prevent the ram from falling
when the punch is complete.
10. Release the pressure at the pump.
Punch
1-1/8" Sleeve
Punch
Die
3/8" Adapter
Draw Stud
Spacer
3/4" Draw Stud
Ram
Die
Material
Punch Die Spacer
as needed
Material
Material
Completed Assembly
To Next Page
Loading...