EasyManuals Logo

GreenTech pureWash ProX2 User Manual

Default Icon
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
6. Clothes are being bleached.
pH of the water in your area is too high.
If you have a top load washer and are experiencing a bleaching or spotting
effect on your clothing, a top load washer diffuser is available by contacting
www.greentechenv.com/contact-us or calling 1.800.621.7201.
7. Suds in the basin after first uses.
Detergent or residue is being cleaned out.
Run multiple washes without clothing until the detergent residue is gone. For older
washing machines, large amounts of detergent, especially if powder detergent
was previously used, may be trapped inside your washing machine. pureWash
will break up this caked on detergent. If you see specks of white material in
your clothing after the spin cycle, it is probably old detergent. Run loads without
clothing until bubbles are gone indicating residual detergent has been removed.
8. Discoloration occurs in the viewing tube.
High Tannin levels in your water source.
The use of a pre-filter is required. Contact local water specialist to find proper
filter to remove Tannins.
9. Clothes have a rusty colored stain to them.
High Iron levels in your water source.
Do not dry or bleach the clothes as it will worsen the effects. Re-wash them in a
clean water source before drying. The use of our pre-filter (page 16) or an Iron
specific pre-filter is required.
TROUBLESHOOTING CONTINUED

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GreenTech pureWash ProX2 and is the answer not in the manual?

GreenTech pureWash ProX2 Specifications

General IconGeneral
BrandGreenTech
ModelpureWash ProX2
CategoryWater Dispenser
LanguageEnglish