To Next PageTo Next Page
Need help?Do you have a question about the Greentek RNC12 HRV and is the answer not in the manual?
Safety warning about installation location and servicing.
Ensuring proper operation and compatibility with other mechanical systems.
Specifies the product is for residential applications only and must follow codes.
Safety precautions for operation and efficiency, including electrical and physical hazards.
Calculates ventilation needs based on room count and required airflow per room.
Calculates ventilation needs based on total house volume and air changes per hour.
Dedicated duct system for supply and exhausting stale air in the home.
Dedicated duct system for exhausting stale air, distributing fresh air via forced air system.
Guidance on selecting an appropriate location for the HRV/ERV unit for accessibility and performance.
Details on using UL 181B listed materials, air connectors versus air ducts, and insulation.
Installation requirements and important considerations for the ventilation hood.
Performance curves showing static pressure vs. airflow for exhaust and supply air.
Explanation of the selector switch for Intermittent, Continuous, and Off modes.
How to increase or decrease motor speed using the control buttons.
Lists required tools and important considerations before performing unit balancing.
Step-by-step guide for balancing the unit using the Duotrol™™ system.
How to use the selector switch and understand the Green/Yellow indicator lights during balancing.
Lists required tools and considerations for balancing RNC 1.0/RNC12 models with integrated dampers.
Step-by-step guide for balancing RNC 1.0/RNC12 units using integrated dampers.
Important notes on defrost sequence completion and installer information for RNC 1.0/RNC12.
Wiring diagrams for connecting Vectra Series EHC 1.0 and EHC 1.5 wall controls.
Wiring diagrams for RD-1 (2-wire) and RD-2/3P/4P (4-wire) wall controls.
Wiring diagrams for connecting the T3 Timer (3-wire) control.
Wiring diagram for standard integration with forced air systems via internal relay.
Wiring diagram for systems where thermostat controls A/C, requiring alternate interlock wiring.
Diagnosing and resolving issues when the HRV/ERV is not operating.
Addressing problems related to air being too dry or too humid.
Troubleshooting causes of vibration, noise, or cold air output.
Resolving issues related to contaminants and condensation.
Instructions for cleaning or replacing air filters every two to three months.
Cleaning exterior vents and the heat-exchange core twice a year.
Checking the condensate drain and servicing the fans for continuous operation.
Recommendation for annual general servicing by a certified contractor.
General
