You can start the exclusion process through your Gateway user interface or by pressing and holding the Gateway
network button for ve seconds until the “exclusion mode” pattern appears on the Gateway activity indicator. When
this is completed, the Gateway is ready to perform the exclusion of the PowerNode.
To complete the process you must perform the following steps:
1. Unplug the PowerNode from the wall socket.
2. Locate the network button on the PowerNode. It is a small round button on the side of the device,
marked with the sync symbol.
3. Press and hold the network button while plugging the PowerNode into a wall socket. Keep the button
pressed for ve seconds until the activity indicator begins to ash rapidly, indicating that the exclusion
process has completed. Your PowerNode is now free of its former association, and you can perform an
inclusion process to include it in your GreenWave Reality home network (refer to the “Network Inclusion
Process” section above).
If the network indicator and power button symbol ash together slowly for ve seconds, then the exclusion process
failed, and you must start over.
12
To Next Page
Loading...