Why my GreenWorks Commercial Lawn Mower will not start?
If your GreenWorks Commercial Lawn Mower won't start, first ensure the switch key is in the “ON” position. Next, check all battery connections in the back battery compartment and make sure the batteries are fully charged. Finally, verify that none of the circuit breakers have tripped.
Why is my GreenWorks Commercial Lawn Mower vibrating abnormally?
Abnormal vibration in your GreenWorks Commercial Lawn Mower can be due to several factors. It might be caused by bent or unbalanced cutting blades, in which case you should install new cutting blade(s). Another cause could be a loose blade mounting bolt, so you should tighten it.
How to fix uneven cutting height on GreenWorks Commercial Lawn Mower?
Uneven cutting height with your GreenWorks Commercial Lawn Mower can occur for several reasons. The blades may not be sharp, so try sharpening them. Also, a cutting blade may be bent, in which case you should install new cutting blade(s). Other causes include: the deck is not level, an anti-scalp wheel is not set correctly, the underside of the deck is dirty, or tires improperly inflated. You can level the deck, adjust the height of the anti-scalp wheel, clean the underside of the deck, or adjust air pressure and ensure even pressure between tires to resolve the problem.
General| Cutting Width | 48 inches |
|---|---|
| Motor | Brushless |
| Power Source | Battery |
| Deck Material | Steel |
| Voltage | 82V |
| Drive System | Self-Propelled |
| Brushless Motor | Yes |
| Cutting Height | 1.5 - 4.5 inches |
| Battery Type | 82V Lithium-Ion |
| Self-Propelled | Yes |
| Wheel Size (Front) | 11 inches |
| Run Time | Up to 5 hours |
| Battery Runtime | Up to 5 hours |
To Next Page