EasyManua.ls Logo

GreenWorks Pro 2600402 - User Manual

GreenWorks Pro 2600402
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P0802438-00
P0802438-00
GWK 80V Snow Thrower
2600402LC
技术要求:
2.40P, 内容见电子档;色块要求在最外侧
3.单色印刷,要求无色差、无污点;
4.骑马钉,裁切均匀、无连页;
5.以封样为准;
6.料件需符合格力博HSF文件(编号:GLB-CGR-146) 里关于环保和有害物质的具体要求。
1.材质要求:60g双胶纸;
常州格力博集团
说明书
黄潇笑
刘小娟
周艳
王小妮
李海平
2020.04
版本号
描 复
日 期
工艺
审核
校对
设计
标记
处数
签名
日期
阶段标记
视角标记
重量 比例
批准
审定
标准化
日期
更改文件号
SCALE: A5
210mm
145mm
ABS
B
SNB401
2600402

Questions and Answers

  • J
    jennifer95Aug 11, 2025
    What to do if my GreenWorks Pro 2600402 Snow Blower does not start?
    • T
      Timothy HarrisonAug 11, 2025
      If your GreenWorks Pro Snow Blower doesn't start, there are several potential reasons. First, the battery might not be charged; in this case, charge the battery by following the procedures in the battery and charger manual. Another reason might be a defective switch, which should be replaced by an authorized service center. Also, if the battery is too cold, remove it from the snow thrower, place it on the charger, and allow it to charge for 10 minutes or until the charging light turns green, then remove it from the charger and install it back in the snow thrower for use. Finally, the battery may require service or replacement; call the toll-free helpline at 1-855-345-3934 or replace the battery.
  • M
    martinjessicaAug 21, 2025
    Why does my GreenWorks Pro 2600402 leave a thin layer of snow behind?
    • K
      Keith ArnoldAug 21, 2025
      If your GreenWorks Pro Snow Blower leaves a thin layer of snow behind, the scraper is likely damaged. The suggested solution is to replace the scraper.
  • W
    Wanda JonesSep 1, 2025
    What to do if the engine is on, but the impeller does not turn on my GreenWorks Pro 2600402?
    • V
      Victoria ReedSep 1, 2025
      If the engine of your GreenWorks Pro Snow Blower is running but the impeller isn't turning, the belt is likely damaged. Replace the belt to resolve this issue.

GreenWorks Pro 2600402 Specifications

General IconGeneral
Power SourceElectric
Motor Power13 Amp
Clearing Width20 inches
Clearing Depth10 inches
Throw Distance20 ft.
Weight33 lbs
Chute Rotation180 degrees
HeadlightYes
Motor TypeBrushed
Chute ControlManual
Warranty4 years
Auger TypeSingle-stage

Related product manuals