Need help?Do you have a question about the GreenWorks TL80L00 and is the answer not in the manual?
General| Brand | GreenWorks |
|---|---|
| Model | TL80L00 |
| Category | Tiller |
| Language | English |
The wheels are used to control the depth of operation, and adjust the height of the cultivator.
The cultivator comes with four tines—For correct operation of the unit, the tines must be installed in the correct order.
When the tines are installed correctly, the flute on the tines should line-up, and the angled edge of the tine blades should point towards the ground.
Place tine (A) onto the shaft, and place tine (D) onto the other side shaft. Insert the hitch pin into the holes.
Align the holes on the upper handle with the holes on the lower handle. Insert the bolts, and tighten them using the wing nuts.
Insert the battery into the unit until it clicks securely. Press the Safety-lock out button and pull the Bale Switch upwards.
Release bale switch to stop the cultivator.
The cultivator can be used to break up garden soil and prepare a seed bed for planting. Plan ahead to leave enough room between rows.
Tilling sod into the soil is not recommended. If sod must be removed, it is suggested to do as follows:
Shallow cultivating can disrupt weeds and aerate soil without injuring nearby plant roots. It should be done often.
Press the battery capacity indicator (BCI) button. The lights will illuminate according to the batteries current power level.
It is recommended to fully charge before first use to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory.
If the battery pack does not charge properly: Check the current at the power outlet with another tool.
This charger can be installed hanging on a wall using two #8 screws (not included).
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from commercial solvents.
Clean dirt, grass, and other materials from the entire unit. Wipe the tines with oil or spray them with silicone lubricant to prevent rusting.
Unfold the handles into the upright position and secure by tightening handlebar knobs. Do not allow the switch trigger cable to become pinched.
Any part that has become inoperative due to misuse, abuse, neglect, accident, improper maintenance, or alteration; or the unit if not maintained.
Warranty service is available by calling our toll-free helpline, at 1(855)345-3934.
Transportation charges for the movement of any power equipment unit or attachment are the responsibility of the purchaser.
To Next Page
