FD280/ Translation of the original instructions
3. Turn the lever anti-clockwise (fig. 25)
4. Remove the PTO belt (fig. 22)
5. Release the fork (fig. 20), pull the deck forward and set it vertical (fig. 17). Take care not to bend the adjuster
cables.
6. Remove the pulley (fig. 19A).
7. Take off the cutting deck protection transmission (A fig. 36), unscrewing the 4 screws;
8. Unhook the spring (A fig. 35);
9. Take off and put the belt (ref. B fig. 35), following the schema represented (fig. 35).
USE ORIGINAL BELTS ONLY!
MAINTENANCE SUMMARY TABLE
PROCEDURE EVERY 8
HOURS
AFTER
20
HOURS
EVERY
40
HOURS
EVERY
50
HOURS
EVERY
100
HOURS
EVERY 200 HOURS
Engine oil
check the level ●
change ● ●
Air filter
check ●
replace ٭
Spark plug
check/adjust ●
replace ●
Hydrostatic
axle oil
check the level ●
replace
(first
change)
●
●
Check that the engine intake
grid is clean
●
Check that the hydraulic
engine cooling fins are clean
●
Check that blades are well-
sharpened and well-fixed
●
Lubricate with grease
●
● recommended procedure
٭ procedure to be carried out if necessary
12
To Next Page
Loading...
