EasyManua.ls Logo

Grimac TERRY TECH - 5.2 Descaling Instructions

Grimac TERRY TECH
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 8
Chapter 5 - Maintenance
- Approx. every 300 coffees, clean the lter by submersing it in a water and salt
solution (regeneration). Filter life depends on the hardness of the water.
- After approx. 10-12 months replace with a new lter.
EXTERNAL HOUSING: to keep external housing clean, use a sponge or cloth soaked
with a cleaning product - neutral detergent.
Do not use solvents, abrasive powders, or scouring pads to clean.
5 . 2 - D E S C A L I N G I N S T R U C T I O N S
To descale the TERRY TECH pod coffee maker proceed as follows:
Disconnect the water softener filter from the silicone tube.
Disconnect the silicone tube from the water tank.
In a container/bowl dilute a sachet of Detercaf descale in half a litre of water and place
the tube in this solution.
Proceed as if you were dispensing coffee several times.
Once the descale solution finishes, fill the container/bowl with clean water.
Run a few more cycles to flush out all traces of the descale solution.
Make sure there are no traces of this descale solution in the coffee maker.
Reconnect the tube to the water tank.
Reconnect the water softener filter to the tube.
Depending on use and water hardness, we recommend you descale your cof-
fee maker at regular intervals.
To regenerate the water softener filter located inside the tank, leave in a salt water solu
-
tion for 8 to 10 hours.
Before replacing the water softener filter always thoroughly rinse under running water.

Related product manuals