Grindlux 4000 - Final Grinding Steps and Disc Change; Completing the Sharpening Cycle; Changing the Grinding Disc

English – 11
WARNING!
Wear protective glasses while
grinding!
Fitting the Bandsaw Blade
Fit the bandsaw blade on the one-man sawmill
according to the instructions in the operator´s
manual for the one-man sawmill.
Changing the Grinding Disc
WARNING!
Before changing the grinding
disc, disconnect the power
supply to the grinder!
WARNING!
Check that the grinding disc
shows no signs of cracking and
that it is secured to the spindle.
Stop the grinding disc immedi-
ately if abnormal vibrations
occur.
MAINTENANCE
1. Fit the stop pin (Q).
2. Start the grinding disc and feed using the
power switches (49 and 50).
3. When the grinder stops automatically,
remove the stop pin.
4. Fold up the grinding motor and remove the
bandsaw blade.
1. Fold up the top section of the grinder.
2. Hold the grinding disc and loosen the nut (R)
using a pair of pliers.
3. Remove the old grinding disc and fit the new
disc. Tighten the nut (R) lightly using a pair of
pliers.
!
!
!
FIG. 89
FIG. 90