The Anti-Tip Bars are shipped at GRIT’s recommended length. The length can be adjusted to
make the bars more secure or more permissive. To adjust the bar length:
• Use the 5mm hex key to loosen the clamps.
• If shortening the Anti-Tip Bars, slide the sliver bars off, and remove the spacer. Note that a
second spacer is included inside and is glued in. Do not remove this second spacer, as over-
shortening the bars will render them ineffective. With the second spacer inserted, the bars
are safe to use in most riding conditions.
• If lengthening the Anti-Tip Bars, slide the sliver bars to the desired length and tighten.
Additional spacers have been provided for your convenience, but are not required.
• Use the 5mm hex key to tighten the clamps. Make sure the bars are at the same length.
To Previous Page
Loading...