GRIT Junior User Manual

Have a question? Call 617-356-8106 or email support@gogrit.us.
GRIT Junior: Anti-Tip Bars Installation Guide
1
Remove the nut and
washer from one of
the two rear seat
bolts. Keep the bolt in!
Just take off the nut
and washer.
2
Slide the Anti-Tip Bar
over the exposed bolt
thread. Tighten the
nut back onto the bolt.
Do not include the
washer!
Tools Required:
Large Phillips (cross-head) screwdriver, 13mm (or adjustable) wrench, 5mm hex key (came with your
Freedom Chair)
These Anti-Tip Bars help you ride securely by making it harder to tip the Freedom Chair backward. They
come pre-set in a safe riding position. You may adjust their length.
!
The Anti-Tip Bars cannot prevent every possible accident:
•
You are responsible for your safety. Ride within your limits. If you feel unsafe, stop.
•
Ride with a spotter behind your chair while getting used to the Freedom Chair and Anti-Tip Bars,
especially on ramps and uneven terrain.
•
Do not build up backward momentum. Rolling backward on a ramp, even with Anti-Tip Bars
installed, is dangerous and could cause a fall.

GRIT Junior Specifications

General

Frame Material	Aluminum
Adjustable Footrest	Yes
Foldable	Yes
Terrain Type	All-terrain
Overall Width	24 inches
Wheel Size	24 in
Category	Manual
Seat Width	14 inches
User Height	4'6" - 5'6"

Summary

Anti-Tip Bar Installation Steps

Remove Rear Seat Bolt Components

Remove the nut and washer from one of the two rear seat bolts, keeping the bolt.

Attach Anti-Tip Bar to Seat Bolt

Slide the Anti-Tip Bar over the exposed bolt thread and retighten the nut without the washer.

Repeat for Second Rear Bolt

Repeat the previous installation steps for the other rear seat bolt and Anti-Tip Bar.

Adjusting Anti-Tip Bar Length

Loosen Clamps for Adjustment

Use the 5mm hex key to loosen the clamps to adjust the bar length.

Shortening the Anti-Tip Bars

Slide bars off, remove the spacer. Do not remove the second internal spacer.

Lengthening the Anti-Tip Bars

Slide bars to the desired length and tighten the clamps.

Secure Adjusted Bars

Use the 5mm hex key to tighten clamps, ensuring bars are at the same length.