Grizzly Tools G0513X2 User Manual

Page 1
Grizzly Bandsaw SOP
This Bandsaw runs on 220V (208V really because, 3 phase power).
Set blade guide rollers to appropriate height for the piece you are
cutting.
The rollers should be close to your piece.
Keep hands and fingers away from blade, use push sticks and/or T-
square pusher.
Be very careful while resawing and use a push stick.
The off button has to be twisted to reset itself.
Please read the next 14 pages of this guide to gain an understanding of
the operation of the Bandsaw itself.
The full manual is available online and a paper copy is here in the shop.

Grizzly Tools G0513X2 Specifications

General

Type	Bandsaw
Weight	250 lbs
Cutting Capacity (Maximum Width)	13 inches
Cutting Capacity (Maximum Height)	12 inches
Blade Speed	3000 FPM
Dust Port	4 inches
Max Cutting Width	18-1/2"
Max Cutting Height	12"

Summary

Basic Controls Overview

Control Panel Functions

Details the 2-button power switch and key-based disabling for machine security.

Front Control Components

Explains blade tension scale, handwheel, tracking window, and fence/miter gauge.

Motor Brake Operation

Describes the motor brake function on specific models for quick stopping.

General Safety Precautions

Apparel and Personal Safety

Proper Tool Usage

Guards and Cover Integrity

Unattended Operation Prohibition

Maintenance and Care

Damaged Part Inspection

Advises inspecting and repairing/replacing damaged parts before use.

Bandsaw Specific Safety

Hand Placement Safety

Warns against placing hands near the moving blade during operation.

Small Workpiece Handling

Advises using push sticks or fixtures for small/narrow workpieces.

Blade Speed Requirement

Blade Condition and Maintenance

Blade Stop Procedure

Instructs to let the blade stop on its own; do not use hands.

Guard and Cover Usage

Stresses operating only with guards and covers properly in place.

Upper Blade Guide Setup

Safe Cutting Techniques

Workpiece Support

Test Run Procedure

Initial Verification Steps

Outlines steps to verify motor power and safety mechanism functionality.

Troubleshooting Noise/Vibration

Advises reviewing troubleshooting for unusual noise or vibration issues.

Tensioning the Bandsaw Blade

Flutter Method for Tensioning

Details a method for tensioning the blade by observing flutter.

Deflection Method for Tensioning

Details a method for tensioning the blade by measuring deflection.

Adjusting Blade Support Bearings

Bearing Adjustment Controls Guide

Describes controls for adjusting upper and lower support bearings.

Adjusting Blade Guides

Upper Blade Guide Adjustment

Details steps for adjusting the upper blade guides' side-to-side position.

Adjusting Blade Guide Bearings

Tooth Contact Warning

Cutting Operations

90-Degree Crosscutting Guide

Details steps for performing a precise 90-degree crosscut.

Resawing Introduction and Blade Choice

Introduces resawing and discusses blade selection considerations.

Resawing Safety Warning

Warns about wandering blades and emphasizes push block use during resawing.