STEP 1
Assemble the outer ends to the base
using 4 x 60mm bolts
STEP 2
Assemble side to ends
using 4 x 70mm bolts
x1
x2
60mm bolts Cot base
End panel
Do not tighten bolts at this stage
Do not tighten bolts at this stage
x1x4
70mm bolts Cot side #1
HIGH:
Newborn level
LOW:
Infant level
WARNING
TO PREVENT FALLS, THE MATTRESS
BASE OF THIS COT SHOULD BE
ADJUSTED TO THE LOWEST POSITION
BEFORE CHILD CAN SIT UP.
! !
WARNING
TO PREVENT FALLS OR
SUFFOCATION, THE MAXIMUM
MATTRESS THICKNESS SHOULD NOT
EXCEED
120MM
! !
x4
To Next Page
Loading...
