How to troubleshoot no sound on a Ground Zero Amplifier?
If your Ground Zero Amplifier has no audible sound, verify the protection fuse(s) of the amplifier (harness), the remote wire connection (RCA input mode), the +12 Volt power supply wire connection, and the ground wire connection. Also, check for speaker shorts or amplifier overheating.
What to do if my Ground Zero Amplifier turns off at high volume?
If your Ground Zero Amplifier turns off at medium or high volume, check that each speaker load impedance matches the technical specifications of the amplifier.
What to do if the status LED is red on my Ground Zero Amplifier?
If the status LED on your Ground Zero Amplifier is red, it indicates that the temperature protection circuit is active or there is a short in the speaker wires or a damaged speaker. Try decreasing the head unit's volume and allow time for cooling. Also, inspect the speaker and wires for any shorts, and insulate if necessary.
Why won't my Ground Zero Amplifier turn on?
If your Ground Zero Amplifier does not turn on, check the power wire and its connections, as well as the remote wire connection to the head unit.
How to fix no sound on one channel of Ground Zero Amplifier?
If there is no sound on one channel of your Ground Zero Amplifier, check for short circuits or open connections. Also, reverse the left and right RCA inputs to check the audio input signal.
Details the high-quality development and audio reproduction of the Uranium series.
General| Category | Subwoofer |
|---|---|
| Series | URANIUM |
| Power Handling (RMS) | 1000 W |
| Power Handling (Peak) | Varies by model |
| Voice Coil | Varies by model |
| Xmax | Varies by model |
| Fs | Varies by model |
| Qts | Varies by model |
| Vas | Varies by model |
| Sensitivity | Varies by model |
| Frequency Response | Varies by model |
| Magnet Weight | Varies by model |
| Mounting Depth | Varies by model |
| Enclosure Recommendation | Sealed or Ported |
| Size | 15 inch |
To Next Page