www.hzgrow.com
User manual for control board K216
Technical parameter：
P1: Power supply：DC10V--30V
P2: Output：Relay（Max. current: 10A）
P3: MX 1.0-6P Fingerprint Module
P4: MX 1.25-6P Fingerprint Module
Standby current：6mA（DC12V）
Fingerprint capacity：300 pieces
Instructions for control board：
1. SET Button:
1.1 Press SET button shortly,system in register state and indicator light flash fast, press
two times for each fingerprint, fingerprint register successful when hearing music.
Fingerprint can be registered continuously when system in register state; if no need
adding fingerprint more, waiting 8 seconds.(Fingerprint capacity is 100 pieces when
press SET button, the registered fingerprints are stored in database 01)
1.2 When back to factory default, press SET button until hear “Di” long beep and
music,means initialization operation successful
2. Remote Control:
2.1 Red indicator lighted means in programming stated, music means operation
successful, default password: 123456，password length: 6numbers
2.2 Change password: Press *password*1*new password*new password#
2.3 Register fingerprint: Press*password*2*DD# , DD from 00 to 02(00, 01 and 02 refer
to three different fingerprint databases), each database can store fingerprint 100
pieces； Exit fingerprint in register state when press * button or waiting for 10s.
To Next Page
Need help?
General