6.2.2.1.Autotest
Connect the Inverter and the PC by RS232;
Power on the inverter, check the inverter com address, and wait the inverter to
connect to grid;
Open the PC software ShineBus, and select page “5 Auto Test”; set the PC com
port(COM) and the inverter com address(Inv Add);
Click button “Test” to test the SPI function;
Wait the test finish, there are 8 levels testing;
The test result data is saved in the “Auto test report of xxxxxx .txt” under the
Software install direction;
40 41
To Next Page