Need help?Do you have a question about the GrowlerWerks uKeg Go and is the answer not in the manual?
General| Brand | GrowlerWerks |
|---|---|
| Model | uKeg Go |
| Category | Dispenser |
| Language | English |
Steps for cleaning and preparing the uKeg for use.
Procedure for inserting the CO2 cartridge into the uKeg.
Instructions for securely attaching the uKeg cap.
Setting the cap dial to the initial dispense position.
Final steps for dispensing and enjoying the beverage.
Instruction to clean the uKeg by hand.
Procedure for rinsing the cap and sleeve with hot water.
Steps to fill, pressurize, and flush the uKeg.
Instructions for removing the cap and shaking out the bottle.
Rinsing the cap and sleeve again with hot water.
Instructions to allow the uKeg parts to dry in a clean place.
Procedure to unscrew the cleaning port on the cap.
Using a brush or pipe cleaner for cleaning the dip tube.
Rinsing the tube and port screw with hot water.
Re-installing the cleaning port screw after cleaning.
Information regarding wear on the cartridge seal and CO2.
Potential issues caused by debris in the flow path.
Importance of adhering to cleaning procedures.
Steps to remove the cap and then the faucet for cleaning.
To Next Page