Do you have a question about the Grundfos ALPHA 15-55 HWR-D and is the answer not in the manual?
Model | ALPHA 15-55 HWR-D |
---|---|
Max Operating Pressure | 10 bar |
Material | Cast iron |
Max. operating pressure | 10 bar |
Frequency | 50 Hz |
Insulation class | F |
Head Range | 5.5 m |
Power Consumption | 45 W |
Impeller Material | Composite |
Voltage | 230 V |
Verify product condition and specifications upon arrival for correct operation.
Lists all components included in the product package for initial setup.
Guidance on selecting an appropriate and safe installation location for the pump.
Lists the necessary tools required for the installation process.
Instructions on how to properly insulate the pump housing to prevent heat loss.
Detailed procedures for physically connecting the pump to the piping system.
Instructions for safely connecting the pump's electrical components to the power supply.
Procedure to remove air from the system before or during pump operation.
Steps to safely start the pump after installation and venting.
Overview of the ALPHA HWR-D system and its function.
Details about optional or included accessories for the pump system.
Specifies the intended applications and purpose of the HWR-D system.
Information on suitable and unsuitable liquids for pumping.
Details on product identification, including nameplate information.
Lists certifications and compliance information for the product.
Explains the LEDs and buttons on the pump control panel.
Describes the LED indicators on the temperature sensor.
Explains the LED status indicators on the push-button.
Indicates the operational status of the repeater via its LED.
Graphical representation of the pump's performance characteristics.
General guidance on keeping the pump in good working order.
Procedures for replacing batteries in the push-button and sensor.
A table listing common faults, their causes, and recommended solutions.
Provides operational parameters such as voltage, temperature, and pressure limits.