Grundfos GT-CF - Page 8

Declaration of conformity
8
The products are diaphragm pressure expansion tanks.
All products are examined under these conditions:
Fluid group: 2.
Module: B + D.
Design standard: ANSI / WSC (Water System Council) PST2000-2005 Pressurized Water Tank Standard.
EC/EU-type examination certificate No:
Notified body:
Manufacturer:
See table below.
CE 0038 - Lloyd's Register Verification Limited, 71 Fenchurch Street London EC3M 4BS
UK.
GRUNDFOS Holding A/S, Poul Due Jensens Vej 7, 8850 Bjerringbro, Denmark.
Type
Maximum
pressure
[bar]
Volume
[litres]
Category used Certificate number
GT-C 8.6 60-450 IV
0038/PED/20040012/I
GT-CF 8.6 60-200 IV
GT-D 10 60-450 IV
GT-DF 10 80-325 IV
The products are diaphragm pressure expansion tanks.
All products are examined under these conditions:
Fluid group: 2.
Module: H.
Design standard: ANSI / WSC (Water System Council) PST2000-2005 Presurized Water Tank Standard.
EC/EU-type examination certificate No:
Notified body:
Manufacturer:
See table below.
CE 0038 - Lloyd’s Register Verification Limited, 71 Fenchurch Street London EC3M 4BS
UK.
GRUNDFOS Holding A/S, Poul Due Jensens Vej 7, 8850 Bjerringbro, Denmark.
Type
Maximum
pressure
[bar]
Volume
[litres]
Design standard Certificate number
GT-H 10 8-200 ANSI/WSC PST
2000 - 2005
01 202 ROC/Q-12 0246GT-H 16 80-160 EN 13831:2007
GT-H stainless steel 10 8-30 ANSI/WSC PST
2000 - 2005
– Pressure Equipment Directive (2014/68/EU).
This EC declaration of conformity is only valid when published as part
of the Grundfos installation and operating instructions (publication
number 98042769 1116).
Bjerringbro, 8th August 2016
Svend Aage Kaae
Director
Grundfos Holding A/S
Poul Due Jensens Vej 7
8850 Bjerringbro, Denmark
Person authorised to compile technical file and
empowered to sign the EC declaration of conformity.