Grundfos MGE 100 Series - Page 25

English (GB)
25
Continued from page 24.
Advanced control panel
"Settings" CME
Multimotor
system
Section Page
""Special functions"" ●●
""Ramps"" ●●10.16 "Ramps" 42
""Standstill heating"" ●●10.19 ""Standstill heating"" 42
""Communication"" ●●
""Pump number"" ●●
10.22 "Number" (""Pump
number"")
43
""Enable/disable radio comm."" ●●
10.23 "Radio communication"
(""Enable/disable radio comm."")
43
""General settings"" ●●
""Language"" ●●10.24 ""Language"" 43
""Set date and time"" ●●
10.25 "Date and time" (""Set date
and time"")
43
""Units"" ●●
10.26 "Unit configuration"
(""Units"")
43
""Enable/disable settings"" ●●
10.27 "Buttons on product"
(""Enable/disable settings"")
43
""Delete history"" ●●10.28 ""Delete history"" 44
""Define Home display"" ●●10.29 ""Define Home display"" 44
""Display settings"" ●●10.30 ""Display settings"" 44
""Store actual settings"" ●●
10.31 "Store settings" (""Store
actual settings"")
44
""Recall stored settings"" ●●
10.32 "Recall settings" (""Recall
stored settings"")
44
""Run start-up guide"" ●●10.35 ""Run start-up guide"" 45
1)
Only available if an advanced functional module, type FM 300, is fitted.
"Assist" MGE
Multimotor
system
Section Page
""Assisted pump setup"" ●●
10.39 ""Assisted pump setup""
(Assisted motor setup)
45
""Setup, analog input"" ●●10.40 ""Setup, analog input"" 46
""Setting of date and time"" ●●
10.25 "Date and time" (""Set date
and time"")
43
""Setup of multi-pump system"" ●●
10.42 ""Setup of multi-pump
system"" (Multimotor)
46
""Description of control mode"" ●●
10.43 ""Description of control
mode""
49
""Assisted fault advice"" ●●10.44 ""Assisted fault advice"" 49