Need help?Do you have a question about the Grundfos MGE 132 Series and is the answer not in the manual?
General| Motor type | Permanent Magnet Synchronous Motor (PMSM) |
|---|---|
| Frame size | 132 |
| Efficiency Class | IE5 |
| Frequency | 50/60 Hz |
| Protection Class | IP55 |
| Insulation Class | F |
| Voltage | 3 x 380-500 V |
| Cooling Method | IC411 |
| Ambient Temperature | -20°C to +40°C |
| Mounting | B3, B5, B14 |
Indicates a hazardous situation that could result in death or serious personal injury.
Indicates a hazardous situation that could result in death or serious personal injury.
Location and explanation of the motor's nameplate details.
Explains the coding system used for motor type designation.
Safety precautions and guidelines for handling the motor during installation.
Instructions and safety advice for securely mounting the motor to a foundation.
Measures for protecting against electric shock and indirect contact.
Specifies cable cross-section requirements for single-phase and three-phase supplies.
Lists available single-phase voltages and frequencies for the motors.
Details about the basic module's inputs, outputs, and connections.
Overview of the basic control panel's components and functions.
How to make settings using R100 or Grundfos GO.
How to set the desired setpoint using the control panel, with examples.
How to start and stop the motor using the control panel buttons.
How Grundfos GO communicates with the motor via radio or infrared.
How to set the desired setpoint for all control modes.
Overview of possible control modes: Constant other value and Constant curve.
Explains available analog inputs and how to set their functions.
Details on functions like Linear, Inverse, and their variations for setpoint influence.
Step-by-step setup instructions for multimotor systems using Grundfos GO or advanced control panel.
To Next Page