EasyManua.ls Logo

Grundfos MGE 160 Series - User Manual

Grundfos MGE 160 Series
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MGE motors
Installation and operating instructions
GRUNDFOS INSTRUCTIONS

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Grundfos MGE 160 Series and is the answer not in the manual?

Grundfos MGE 160 Series Specifications

General IconGeneral
BrandGrundfos
ModelMGE 160 Series
CategoryEngine
LanguageEnglish

Summary

Installation and Electrical Setup

Mechanical Installation

Covers handling, mounting, cable entries, and cooling for mechanical setup.

Motor Mounting Instructions

Details on securely mounting the motor to a foundation using bolts.

Ensuring Motor Cooling

Specifies minimum distances required for adequate motor cooling.

Electrical Installation Safety

Crucial safety precautions for electrical installation, including power disconnection.

Protection Against Electric Shock

Details on protective earthing and indirect contact protection as per local regulations.

Motor Operation and User Interfaces

Motor Functions and Settings

Setpoint Configuration

How to set the motor's desired setpoint for various control modes.

Operating Mode Selection

Describes available operating modes: Normal, Stop, Min., Max., and Manual.

Manual Speed Setting

Instructions for setting motor speed manually as a percentage of maximum.

Control Mode Options

Explains 'Constant other value' and 'Constant curve' control modes.

Analog Input Configuration

Details available analog inputs and their functions based on the module.

Pt100;1000 Input Configuration

Details available Pt100/1000 inputs and their functions based on the module.

Digital Input Configuration

Explains digital input functions like stop, speed control, and timer settings.

Configurable Digital Inputs;Outputs

Details configuring digital inputs/outputs for various functions and timer modes.

Signal Relay Outputs

Describes the two signal relays and their activation based on motor status or events.

Analog Output Configuration

Details analog output signals for reading operating data and their ranges.

Controller Settings and Tuning

How to adjust controller gain (Kp) and integral time (Ti).

Setting the Operating Range

How to define the motor's operating range by setting minimum and maximum speeds.

External Setpoint Influence

How external signals can influence the motor's setpoint.

Setpoint Influence Function Options

Describes functions like Linear, Inverse, and Influence Table for setpoint adjustment.

Predefined Setpoint Configuration

Setting up to seven predefined setpoints using digital inputs.

Limit Exceeded Functionality

Monitoring parameters against limits to trigger actions like warnings or stops.

Motor Acceleration and Deceleration Ramps

Setting motor acceleration and deceleration times.

Assisted Motor Setup Procedure

Guided process for setting up the motor's control mode, sensors, and parameters.

Analog Input Setup Guide

Guided setup for analog and Pt100/1000 inputs.

Multimotor System Setup

Steps to configure multimotor systems for parallel operation.

Alternating Operation Modes

Details alternating operation based on time or energy for duty/standby.

Technical Data and System Integration

Priority of Settings and Commands

Defines the hierarchy of commands from different sources.

Related product manuals