Grundig GDT 310 - Using Your Phone: List Management; Internal Calls and Intercom

ENGLISH
14
USING YOUR PHONE
_________________________________
Delete a Redial Number
1 Follow Steps 1 and 2 in section Re-
dial a Number from the Redial List
2 Press » « and » « to select
DELETE.
3 Press » « to confirm.
Delete the Entire Redial List
1 Follow Steps 1 and 2 in section Re-
dial a Number from the Redial List
2 Press » «and » « to select DE-
LETE ALL.
3 Press » « to confirm.
4 Press » « to confirm again.
Find the Handset
You can locate the handset by pressing
» « on the base station. All the hand-
sets registered to the base will produce
the paging tone and “PAGING” is dis-
played on the LCD. You can stop the
paging by pressing » «/ » « / » «
/ » « on any handset or » « on the
base again.
Note:
█
If there is an incoming call during
paging, the phone will ring with
the incoming call instead of pag-
ing.
Make an Internal Call
This feature is only applicable when
there are at least two registered hand-
sets. It allows you to make internal calls,
transfer external calls from one handset
to another handset and make confer-
ence calls. If the called handset is not
answered within 60 seconds, the called
handset will stop ringing and the calling
handset will return to standby mode.
Note:
█
If only one handset is registered
to the base station, press » «
will display “NOT POSSIBLE”
Intercom Another Handset
1 In idle mode, press » « and the
registered handsets will display ex-
cept the calling handset.
2 Enter the desired handset number to
intercom with.
3 The called handset rings and press
» «on the called handset to estab-
lish the internal call.
Note:
If two handsets are registered to the
base station, press » « will connect
to another handset immediately.
Call All Handsets
1 In idle mode, press » « and the
registered handsets will display.
2 Press » KEY 9 « to ring to all regis-
tered handsets.