ENGLISH
23
OPERATION
__________________________
Notes
7
Repeat the procedure section by
section.
7
If you have thick hair, you might
have to repeat this procedure on
the same section several times.
8 After use, switch the appliance off
by pushing the On/Off switch
B
.
The mode indicator LED
C
turns
off. Then unplug the power cord
F
.
Notes
7
Never leave the appliance unat-
tended while it is plugged in.
7
Unplug the power cord after use.
7
Allow the appliance to cool in a
safe place.
Styling waves or curls
Caution
7
The housing of the appliance be-
comes very hot near the heating
plates. Do not touch the housing
near the heating plates.
7
Place the appliance on a solid,
flat, heat resistant surface. Do not
place the appliance on any soft
or uneven surfaces such as car-
pets, rugs or bedding and never
cover.
7
Make sure your hair is com-
pletely dry.
1 Plug the power cord
F
into the
wall socket.
2 Switch the appliance on by push-
ing the On/Off switch
B
.
– The mode indicator LED
C
lights up in blue.
3 Turn the temperature setting
wheel
D
between »+« and »–«
to adjust the required heat.
Notes
7
Adjust to the lowest temperature
the first time you use it.
7
The appliance is able to reach
a maximum temperature in 60
seconds.
4 Comb or brush out a section of
your hair about 3 cm wide, start-
ing at the neck.
5 Place the section of hair between
the solid ceramic plates
A
as
close to the hair line as you can,
and then close them.
Caution
7
Do not touch the ceramic plates
as they are very hot.
To Next Page
Loading...
