General functions
Switching on and off
1 Press »ON/OFF« to switch the device on and
off.
Adjusting the volume
1 Adjust the volume using »
+
VOL. –«.
DAB mode
For the best DAB reception, simply direct the wire
antenna accordingly.
Selecting the input source DAB
1 To select DAB radio as input source, press
»MODE SCAN ALARM« for a short time.
– Display: »DAB«, then the name of a DAB ra-
dio station.
Selecting stored stations
1 Select the station you want by using the preset
buttons »1, 2, 3, 4, 5« (presets 1 to 5) or using
»+ 5« and the preset buttons »1, 2, 3, 4, 5«
again (as changed to presets 6 to 10);
or
select the desired station from the station list.
Displaying DAB station information
1 To display information on the current DAB sta-
tion, press »SELECT/INFO« repeatedly.
– The following display appears in succession:
Information from the provider (e.g. actual
broadcast, title of the song, e-mail address),
signal strength, genre, current frequency, refer-
ence to signal interference (at optimum signal
display »ERR: 0«), bit rate, broadcasting for-
mat, current time and date.
Setting Dynamic Range Control
(DRC) for DAB stations
When you activate Dynamic Range Control, you
can hear lower sounds better in a loud environment.
1 Open the menu with »MENU«.
2 Select the option »DRC« with »+ VOL. -« and
press »SELECT/INFO« to confirm.
– Display: »DRC OFF«.
3 Select the option “DRC LOW” or “DRC HIGH”
with »+ VOL. -« and press »SELECT/INFO« to
confirm.
4 Press »MENU« to end the display.
Note:
7
The DAB station must support DRC.
FM mode
For the best FM reception, simply direct the wire
antenna accordingly.
Selecting the input source FM
1 To select FM radio as input source, press
»MODE SCAN ALARM« for a short time.
– Display: »FM«, then the frequency of a FM
radio station.
Selecting stored stations
1 Select the station you want by using the preset
buttons »1, 2, 3, 4, 5« (presets 1 to 5) or using
»+ 5« and the preset buttons »1, 2, 3, 4, 5«
(as changed to presets 6 to 10).
Displaying RDS station informations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:
7
It may take some time before all RDS infor-
mation is available.
7
GRUNDIG has no responsibility for the ac-
curacy of such information.
1 Press »SELECT/INFO« repeatedly.
– The following display appears in succesion:
radio text (if offered), station type (PTY),
name of the radio station, current time and
date.
To Next Page
Loading...
