Safety Precautions
1. Always use eye and body protection when using power
tools such as this grinder.
2. Remove any jewelry or loose clothing which could
become entangled in the grinding head.
3. Set power switch to off before plugging in the grinder.
4. Use only a properly grounded three prong 110 volt 60
cycle outlet. Extension cords are not recommended.
5. Place grinder in an area where water will not reach
electrical outlet and route cord to avoid water
dripping down the cord to the outlet.
6. Turn off grinder when not in use.
7. Do not leave hex wrench or other tools on grinder
when in use.
8. Never grind without water.
Changing Grinding Bits
1. Most brands of standard grinding bits will t this
grinder.
2. To install a new grinding bit, rst remove the old bit
by loosening the set screw in the base of the bit using
the included hex wrench.
3. It is recommended to place a little lubricant, such as
petroleum jelly, on the shaft to aid in future grinding
bit changes.
Operating Instructions
1. Place grinder in area with good ventilation and
lighting.
To Next Page
Loading...
Need help?
General
