Battery Capacity LED
Indicator
Press
the
Power
bu
tt
on
lightly
to check the remaining ba
tt
ery capacity.
I
Indicator
lights
II
5
OFF
lis
Flashing
ll
1
Solid
ON
ij2soli
d oN
II3Solid
oNII4Solid
oN
I
Is
solid
oN
I
I
Battery
Capacity
II
0%
II
10%
II
20%
II
40%
II
60
%
II
80
%
II
100%
I
While
the Powerall
is being charged, the indicator lights will flash
one
by one until
it's at maximum charge (All
5 indicator
lights will
stay on
when the Powerall is
fully charged).
How to Jump Start a Vehicle
Battery:
1. Make sure the battery capacity of the
Powerall
is above
50°
/o
(At least
3 indicator lights
stay ON
).
2. Connect the jump st
ar
t cable to the drained battery of the vehicle.
Connect
red
clamp
to the positive"+"
terminal and
black clamp
to
the negative
"
-"term
inal.
3. Connect the jump start
cable
to
the proper socket of the
Powerall.
4. Now
attempt to crank start the engine.
If
engine does not start,
disconnect the jumper cables and wait at
least 10
seconds before
attempting to start the engine again.
5. Disconnect the jump start
cable
from
the
Powerall
within 10
seconds after the engine has been successfully started.
Recommended Vehicle Engine Displacements
for Jump Starting:
Gas powered
vehicles-
6.0L
displacement
Diesel
powered vehicl
es-
5.0L
displacement
Petrol
powered
vehicl
es-
6.0L
displacement
&,
WARNING!
Do not touch the
red
and
black clamps together
or
connect both to the same piece
of
metal to prevent physical
injury
and
damage to the
ve
hicle.
Do
not
use the jump st
art
cable for
any
other purpose other than
jump
starting the vehicle.
KEEP
AWAY
FROM CHILDREN
AT
ALL
TIMES!
To Next Page
Loading...
Need help?
General