Need help?Do you have a question about the GS Music e7 and is the answer not in the manual?
General| Brand | GS Music |
|---|---|
| Model | e7 |
| Category | Synthesizer |
| Language | English |
Details the two voltage-controlled oscillators for sound generation, including waveform and modulation.
Explains the mixer section for balancing oscillator, sub-oscillator, noise, and external input levels.
Covers the amplifier section for controlling signal amplitude and stereo spatiality.
Details the two ADSR envelope generators for shaping amplitude and filter cutoff over time.
Explains the three LFOs used for periodic parameter modulation, including waveforms and modes.
Selects the oscillator waveform: Triangular, Tri-Saw, Sawtooth, or Pulse.
Adjusts the VCO frequency within a +/- 1/2 semitone range.
Sets the note transposition range +/- 24 semitones.
Sets modulation amount from LFO1 to VCO pitch.
Sets modulation amount from EG1 to VCO pitch.
Sets modulation amount from LFO2 to VCO pitch.
Sets modulation amount from LFO3 to VCO pitch.
Switches the pulse generator ON for waveform shaping.
Synchronizes both oscillators in 'Hard Sync' mode.
Sets the pulse width between 10% and 50% duty cycle.
Sets modulation amount from EG1 to pulse width.
Sets modulation amount from LFO1 to pulse width.
Sets the level of Oscillator 1.
Sets the level of the sub-oscillator derived from OSC 1.
Sets the level of Oscillator 2.
Sets the level of the sub-oscillator derived from OSC 2.
Adjusts the noise generator or external signal level.
Adjusts the low-pass filter cutoff frequency from 10 Hz to 25 kHz.
Sets the amount of emphasis around the cutoff frequency.
Sets the amount of cutoff frequency modulation from EG1.
Sets velocity-dependent cutoff frequency modulation from EG1.
Sets the amount of modulation from LFO1 to the cutoff frequency.
Sets the amount of modulation from LFO2 to the cutoff frequency.
Sets the amount of modulation from LFO3 to the cutoff frequency.
Determines how filter cutoff changes with played notes.
Sets how much the modulation wheel affects cutoff frequency.
Sets how much Aftertouch affects cutoff frequency.
Sets the amount of amplitude modulation from LFO1.
Sets audio signal level before effects or for selected Part.
Sets the amount of amplitude modulation from LFO2.
Details the 24dB/Oct low-pass filter with resonance.
To Next Page