EN
11
Separately battery charge
The battery can be charged separately from the
meter using the DC adaptor supplied with the
Hexylon. Plug the adapter into a properly grounded
electrical supply and the power connector on the
side of the unit.
The ashing light indicates that the battery is
being charged.
If the battery charge is less than 30% the light is
red.
If the battery charge is between 30% and 60% the
light is yellow.
If the battery charge is greater than 60% the light
is green.
The battery pack is placed in the botton-back side
Lift the xings washers and rotate them 90º.
You’ll notice that the xings get out automatically
allowing to remove the battery pack
Put the new battery pack and rotate the xings
washers again until the xings t into the device
Turn your Hexylon on
To Next Page
Loading...