Page 1 of 2
Installation & Operating Instructions
Please read these instructions before use
The RBC range is a new generation of brake controllers utilising microprocessor based technology. It is a compact,
rugged, all electronic brake controller and is easily installed with the connection of four wires and the mounting bracket
supplied. Easily adjustable via the remote control which can be located up to 1m from the controller. Both models also
incorporate an over-ride function for manual control. Designed for both single and dual axle trailers using negative
earth (ground) systems only. Available in 12V & the new 24V version eliminating the need for a separate reducer
on 24V systems.
Specifi cations RBC-12 RBC-24
Minimum Input Voltage 9 VDC
18 VDC
Nominal Input Voltage 12 VDC 24 VDC
Maximum Input Voltage 15 VDC 30 VDC
Output Voltage 12V 12V
Suitable For 12V Trailer Brakes Yes Yes
No Current Load 30 mA
Maximum Load 2 Axel / 12A Avg
Dimensions 40mm x 79mm x 81mm
Weight 200gm
Models:
RBC-12 & RBC-24
12V and 24V
Remote Brake Controllers
Installation :
1. Disconnect the vehicle’s NEGATIVE battery terminal.
2. Determine a suitable mounting location. The unit must be mounted securely to a solid surface.
3. Hold the mounting bracket in the selected position and mark the hole location through the holes in the bracket.
4. Using a suitable drill bit, drill holes in the marked locations.
5. Secure bracket in position with self tapping screws being careful not to strip the holes by over-tightening.
6. Mount the brake control unit in the bracket by snapping into position.
7. Drill two holes in mounting panel to the sticker template and insert control know and LED through holes.
8. Fix locking nut over shaft of control and tighten. Insert supplied LED lens over LED.
9. Connect brake wiring as per wiring instructions and test unit.
Features :
• LED remote indication for brake connected and brake on.
• Easy adjustment via knob rotation in remote
• Convenient Over-Ride via knob push in remote
• Small dashboard mounted remote with 1m cable
• 2 Axle 12A Output Capability
• Top Or bottom Mounting Via The Multi Position Bracket
• Can Be Mounted On Any Angle
Note : The RBC-24 is load activated and can not be tested without load. At no load, output reading of 24V will register.
Please note that the output voltage is PULSED, so it cannot be measured with a volt meter or test light.
CUT HERE CUT HERE
DRILLING TEMPLATE FOR DASHBOARD MOUNTING
Left Circle (LED) = 6.4 mm
Right Circle (Control Knob) = 7.3 mm
Drilling Hole Sizes
Image of Product Sticker
Product comes with:
1x Retaining Nut ( On Unit )
1x Washer ( On Unit )
1x LED Plastic Cover
1x Control Knob
1x Product Sticker
2x Mounting Screws
More information https://www.caravansplus.com.au
To Next Page
Need help?
General