30308397 Page 2 Issue 1.01
Tone, single/dual address mode and consumption
mode can be set as the same as programming the
parameter of a module by P-9910B programmer. Refer
to Table 1 for parameters and P-9910B Installation and
Operation Manual for details.
Working mode can be set as same as programming
device type by the programmer, refer to P-9910B
Installation and Operation Manual for details.
Sounder and strobe (defaulted): 24;
Sounder only: 20;
Strobe only: 21.
In single address mode, the sounder strobe will
sound the preset tone with flash frequency 1.4×
(1±20%)Hz when activated.
In dual addresses mode,
The sounder strobe will sound the pre-alarm
tone (refer to Table 1) with flash frequency
0.7×(1±20%)Hz when activating the first address;
The sounder strobe will sound a preset tone
(refer to Table 1) with flash frequency
1.4×(1±20%)Hz when activating the second
address;
The sounder strobe will sound the preset tone
(refer to Table 1) with flash frequency 1.4×
(1±20%)Hz when activating the first and second
address together.
Wiring diagram
Fig.5 shows that the sounder strobe is
loop-powered.
Sounder Strobe
Z1
D2
D1
Z2
Z1
Z2
Fig. 5
Fig. 6 shows that the sounder strobe is
supplied by an external 24V power.
Sounder Strobe
Z1
D2
D1
Z2
Z1
Z2
D1
D2
Fig. 6
An example shows that how to set the sounder
strobe addressed 25 as dual addresses, tone 15 and
normal consumption mode.
Switch on the P-9910 programmer, input the password
and press the Function key and number 3. Enter 63 and
the Program key. The setting is successful when P
appears on the display. The sounder strobe is now to be
programmed Address No. 25 and 26.
Table 1 shows tone mode, programming method,
consumption for the sounder strobe (Single address,
tone 14 and normal consumption are defaulted).
Table 1
To Next Page
Loading...