To Next PageTo Next Page
Need help?Do you have a question about the GTE SYLVANIA GTE 2600 and is the answer not in the manual?
General| Model | GTE 2600 |
|---|---|
| Category | Stereo Receiver |
| Frequency Response | 20Hz to 20kHz |
| Signal-to-Noise Ratio | 70dB (MM), 80dB (line) |
| Input Sensitivity | 150mV (line) |
| Power Output | 20 watts per channel into 8Ω (stereo) |
Crucial safety advice for qualified personnel and use of genuine parts.
Precautions to prevent electrical shock and fire hazards during servicing.
Detailed steps for performing AC leakage tests on exposed metallic parts.
Procedure to set DC offset voltage at power amplifier outputs.
Steps to adjust idle current for each amplifier panel.
Specifications for power output and distortion across frequencies.
Testing the speaker protection relay activation.
Testing the limiter circuit and clipping indicators.
Expected behavior of the audio mute circuit during power-on and function switching.
Schematic representation of the entire amplifier circuit.
Schematic diagram detailing the tuner's electronic circuits.
Block diagram illustrating the audio signal path through the amplifier.
Block diagram showing signal flow within the tuner section.
List of necessary test equipment for unit alignment.
Detailed procedure for aligning the AM tuner section.
Steps for aligning FM RF and IF stages.
Procedure for adjusting stereo separation using R151.
Table detailing transistor part numbers, types, and applications.
